Paul Allwood's latest activity
-
Paul Allwood replied to the thread DIY press brake.Thanks. I'm lucky that I'm old enough to have used both imperial and metric. Mostly metric now but my old lathe graduations are imperial. -
Wow….thats gonna be one nice brake for sure. (Side note….I wish we would start using the metric system……Well maybe Jimmy Carter will...
-
Paul Allwood replied to the thread DIY press brake.Yeah, needed a way to stop it spinning
-
Doesn't matter how much modern technology one has at their disposal, old school methods can be real handy. Those blue and white reins...
-
Paul Allwood replied to the thread DIY press brake.Thanks. The tooling is 600 mm each, I bought 2 sets for a total of 1200 mm (a good loader bucket width). The vee block is solid and...
-
-
Not sure if this is the right spot for it, but here's some progress on a press brake I'm making so I can make a bucket for the FEL...
-
-
Paul Allwood reacted to Pawnee's post in the thread Zero turn Z242 mower belt way too tight with
Like.
I finally got around to addressing this problem. It won't be as exciting as "Runswithscissors" but here goes. The mower belt has a... -
Paul Allwood replied to the thread B7200 easier steering.Thanks, I'll check it out.
-
I remember doing the calcs for hydraulic steering in a Ag engineering hydraulics course I took 40+ years ago.... but I'd forgotten some...
-
Pictures, please ! :love:
-
Paul Allwood replied to the thread B7200 easier steering.Thanks. Current thoughts on what I might try for the steering are - do away with the mechanical steering box and fit an orbitrol...
-
Balancing the axle loads (adding rear ballast) will help steering effort to some degree. The B7100/7200 steering is basically...
-
Was there a front mounted pump version for power to the FEL on the B7200? That is one way to get a separate (lower) rated FEL pressure...
-
Thats at the pins. Dan
-
Paul Allwood replied to the thread Front loader for a B7200.Thanks Dan. I don't know how to adjust the tractor relief setting yet, but I think I'll leave it alone for now rather than risk leaks...
-
