OntheRidge's latest activity
-
OntheRidge reacted to vdsamuels's post in the thread L6060 tractor loosing and stalling on the brow of hills with
Like.
Thanks for your responses.After a long troublshooting for a few days. I discovered it was dead yellow jack that was found in the fuel... -
Thank you for this explanation
-
OntheRidge reacted to North Idaho Wolfman's post in the thread What does this lever control? with Like.
It's unlocked for loader operation and you can lock it for unintentional loader control usage. And no one is "picking on you", everyone...
-
First it is not a stupid question at all if you just don't know. And the answer to this question could save your life. The lock is to...
-
Nobody is "belittling" you. All you need to "know" as far as general operation is in the owners manual. But if you need further help...
-
OntheRidge replied to the thread Looking at Hoes.Maybe look for a used Kubota TLB series? B26, L47, M62? My L47 is right around 8k pounds with filled rears. Good Luck!
-
Welcome You can pay for a membership https://www.orangetractortalks.com/forums/account/upgrades or install an ad blocker...
-
If you are proud of them you ARE a child. A badly raised child.
-
OntheRidge replied to the thread Daily Chuckle.https://clip.cafe/the-boondock-saints-1999/so-whats-the-symbology-there/
-
Hey everyone - yep, site has been getting busier lately and some of the server-side settings need some "tuning" to accommodate the...
-
The tractor and loader is worth $10,000. Add in all the attachments, and ask $15,000 and take $14,000. You will spend almost that much...
-
DDG on Chrome with Adblock plus (bit defender too) works like a charm. But all of these work so much better when you decide to become a...
-
OntheRidge reacted to Elliott in GA's post in the thread Tonneau Cover Suggestions/Recommendations with Like.
Agree - small included rubber bumpers on panels completely protect the cab's paint. If you damage the cab, it is your fault. 8+ years...
-
My first thought also, but every time you can fire up a machine tool and make chips you are learning , which is always a good thing...
-
OntheRidge replied to the thread Wish I had another inch or so ;).That was my exact thought when I started reading this!