number two's latest activity
-
Nnumber two reacted to Runs With Scissors's post in the thread One hour job takes..... Too long. Like this post. with
Love.
Amen Brother….Words to live by. (y) I only go 1/4 to 1/3 turn, past contact. In 40+ years I have never had a filter “fall off”. I... -
NDryer sheets overwhelm their sense of smell, but if they're desperate for a new home or already live in yours some may stay. Peppermint...
-
NWow!!!!! Thats a lot of damage. My SIL said to use “dryer sheets” at the cottage in our portable ice shanties, and I did…….but I am...
-
NNow that's the type of mind set I expect on an old tractor forum! You will be proven wrong in time, but I'm not wasting mine here...
-
NThat's what I did too. Remove the wheel weights, remove the wheel, unbolt the center and flip it to the desired position, reinstall the...
-
N#70 is really all you need, and find some extra washers laying around:
-
N~50" lengths. Width similar to the grapple claw mouth. Average pitch isn't too bad at ~13%, but the trails tend to change back and...
-
NYep. All of it! You apparently understand how to burn wood. The key is not trying to burn wet wood! :D (Hint to would-be...
-
NCompleted for this firewood season hauling lengths to eventually be cut, split, and stack. Firewood for the '28 heating season at the...
-
NI have the STB1596 version and as @Bee-Positive said, the blade tilt is controlled via the bucket tilt function, and ideally the blade...
-
Nnumber two replied to the thread 2009 B2620 upgrade.Thanks for the explanation! I was about to reply. Good Day to all!
-
NPosition control is the 3pt hitch. The BX, and the older B, had quarter inching. You move the lever up, the 3pt goes up. You let it go...
-
Nnumber two reacted to chim's post in the thread One hour job takes..... Too long. Like this post. with Like.
Here are both ends of the spectrum for me. They have a number of siblings in between. Out of all of them the little guy is so handy...
-
Nnumber two reacted to Tractor Gal's post in the thread One hour job takes..... Too long. Like this post. with Like.
On my BX23D, in order to access the filter, it was necessary to remove the bonnet until I bought one of these. Now, it's a snap...