North Idaho Wolfman's latest activity
-
North Idaho Wolfman replied to the thread Zd28 horrid grinding sound..Start by getting a picture of what your looking at and post it here. There are quite of us that can help you out. -
North Idaho Wolfman replied to the thread OK one more bytch!.Our franchised store in incredible, I haven't had to pay for any of my phones for several years, there is always specials that they...
-
North Idaho Wolfman replied to the thread An Injector Pump Shim Question.If you have the original shims you would just add the amount you mill off the block. If you don't have the original shims or if you...
-
North Idaho Wolfman replied to the thread Kubota Bx24 (D902-e3 Engine).Do you have all the shims for when you removed the old pump? It's not a set amount could be 1 could be 4. If you installed all of those...
-
North Idaho Wolfman replied to the thread Kubota L245F No Throttle Control High RPM at start up.Anything that eats metal.
-
North Idaho Wolfman replied to the thread OK one more bytch!.Sounds like you need a new roll of duct tape to fix it.
-
North Idaho Wolfman replied to the thread L4310e hydro electrical issue how to put in neutral.You should be able to put the range in neutral to move it unless the rear end is locked up, then all bets are off.
-
North Idaho Wolfman replied to the thread B670 Backhoe for B7100.#1 You can not do that, it's an open system. #2 It's going to be slower than snot!
-
North Idaho Wolfman replied to the thread Kubota L245F No Throttle Control High RPM at start up.Make sure you keep the shims for the bottom spring with the same spring or you'll change the pump output. Make sure you install the...
-
North Idaho Wolfman replied to the thread Kubota HD1101A vs DH1101.R&L Supply is a good seller.
-
North Idaho Wolfman replied to the thread Rim Guard ballast and rubber valve stems?.The rubber valve stems are fine and the cores simply coming out would be rather Impossible too. The seal on the core on most rubber and...
-
North Idaho Wolfman replied to the thread B1550 Help.Why do you need to "block it off"? I do believe on that model, that pipe burps air out of the block. Not a good Idea to block it.
-
-
I ate dog once. It was a little ruff going down.
-
North Idaho Wolfman replied to the thread GL281 D1503 Metal vs Graphite head gasket.Here is a source I think close enough for you, for the right gasket...
-
North Idaho Wolfman replied to the thread m4050 VOLTAGE REGULATOR WIRING.I don't see black.... I'm wondering if that is ground. Can you match the pinouts of the original OEM regulator.
