North Idaho Wolfman's latest activity
-
North Idaho Wolfman reacted to whitetiger's post in the thread M5-111 DTC engine U02A3 error ACU with
Like.
During operation, the aftertreatment system may intermittently become disabled, PM level raise, and multiple DTC codes are present. With... -
North Idaho Wolfman replied to the thread Max safe depth for water crossing?.Way too many factors at play to give you a solid answer.
-
North Idaho Wolfman replied to the thread Another wheel spacer question....Do it, then if you have any seal issues, (which is highly unlikely) pull the spacers off before you send it to the dealer. ;)
-
North Idaho Wolfman replied to the thread M4500dt - is it supposed to have coolant reservoir tank?.No they never came with one. Yes you could add one.
-
North Idaho Wolfman replied to the thread Kubota L4310DT gear chunks in hydraulic filter?.Way too many gears to give you any solid answer!
-
North Idaho Wolfman replied to the thread Options and options for Insulating an A-frame.Look at Rockwool comfort board to install on the exterior under roofing. Look at Rockwool or Thermafiber for between studs on the...
-
North Idaho Wolfman replied to the thread m4050 VOLTAGE REGULATOR WIRING.Take a picture of what your looking at. You should not have a dark blue wire going to the regulator.
-
-
North Idaho Wolfman replied to the thread B7200D gear lever leaking hydro fluid.Press fit, heat and pull.
-
North Idaho Wolfman reacted to sweyers's post in the thread B7200D gear lever leaking hydro fluid with Like.
Thanks for that. So these are glue fit or just friction? has anyone installed one. The reverse would be to glue on if loose, compress...
-
North Idaho Wolfman replied to the thread Daily Chuckle.50 CC = 3.05 CI So really not in the same ball park of an increase.
-
Or #3 your compression gauge is off.
-
North Idaho Wolfman replied to the thread Daily Chuckle.Yes you could bore them from a 125cc to a 175cc.
-
North Idaho Wolfman replied to the thread Rubber Mat for transmission cover.You should be A LOT more specific as the L's are not all the same.
-
North Idaho Wolfman replied to the thread B7100 Piston Installation.As long as you installed the pistons and rings properly then, bleed the fuel system to the injectors Then fire it up and run it for a...
