Lencho's latest activity
-
Just started using a little bit bigger brush hog this spring and noticed that on my properties hills I was losing traction. So I went... -
So today I made a temporary bit that held everything in place that made the insides visible as I couldn't get any decent pics or videos...
-
Haha - I do. What you see is the result of a mad flurry of activity in between periods of struggling to get going. And thanks.
-
Lencho reacted to TheOldHokie's post in the thread BH 77 Backhoe on a L2501 boom drifting down and no power to return back to lock position. 207 hours with
Like.
If he did not even mention the relief valves he is clueless. Spool my a$$. I will bet dollars to donuts the relief on one work port is... -
Here…
-
Kubota made the change on most B series tractors a couple of decades ago. The moved the brake pedals to the left when they removed the...
-
The tractor always goes forward, it's the tiller that rotates in reverse or forward directions. If the blades are not facing the right...
-
I have owned my habitat land (57 acres) for 8 years now. I have not found a shed or matching pair , mostly due to the fact I am a full...
-
Lencho reacted to skeets's post in the thread new to me B5200 stalls when clutch is let out. with Like.
I had an old CPO that said when something isnt working and you cant figure it out, look to see where its been kicked before, and then...
-
Lencho reacted to barts's post in the thread Ideas for sidearm/cell phone storage while working. with Like.
<aside> I find the combination of a .45 and some beers somewhat incautious, but perhaps that's just my range training. </aside> Cold...
-
Ok maintenance over and we're back! A little over 40 mins downtime today, not bad.
-
Lencho reacted to MapleLeafFarmer's post in the thread Small trench required...can I remove "teeth" from bucket? with Like.
laying invisibile fence? how much trenching to do? as #40fan says have at'r with a single tooth. not knowing what type of machine you...
-
Lencho replied to the thread curl cylinder seal replacement help.Hi goatiemon, as Kenny says you can’t just pull it out. You need to use the 2 holes in the end cap to turn and drive the square wire...
-
-
Great job! When are you starting on the backhoe?
-
After fighting to connect the ballast box to the 3 point a few times, and after reading some posts from others on here about their use...
