Recent content by JerryMT

What does your owner's manual say? I sure it recommends diesel rated oils , API ratings like CK4, etc

By the way it's sitting in picture #2, it looks like it is" cut into" the gasket. Is this the first change of that filter? Maybe it came to be there during factory assembly. Just sayin'

Start a new post. This one hasn't been active for over a year. We call these "zombies?.

Running a turboed engine at high power and shutting down without a period to cool the turbomachinery can cause severe rubs as the casing cools down quicker that the rotating parts. In many cases it also reduces the oil supply to the turbo bearing. I'm not saying that's what happened here but...

You are a great mechanic!

Did you happen to notice that it's a 35 gallon bucket!

How do you know it's overheating? Sending unit could be bad. Use an infra-red thermometer. If it's really hot, then make sure the thermostat is opening fully. Most often it's the radiator airside that gets clogged with seeds, chaff, and dirt. Make sure you clean it so you and see through it...

I have an M4500 and I rarely use the decompression system but when I do, it kicks off by itself. It only allows a faster spin up on the engine for starting. Igntion of the fuel occurs with the decompression system is closed. As an aside, my operators manual never even mentions it! I found it my...

+1

Sounds like a classic case of restricted fuel delivery. Crud in the tank, plugged fuel filter, water in the fuel, failed lift pump (if it has one). Start at the las line before the injector pump (IP), turn on the key and crank the engine holding a container to catch the fuel. You should see a...

Make sure that you are getting fuel to the fuel injection system and your air cleaner is not clogged.

On a tractor, you need all the dust filtration you can get. K&N filters are not the correction filtration level for any tractor.

+1

With 3000 hrs on the engine, I'd suspect: a) stuck open relief valve, and/or b) loose or cracked oil pump supply tube, and/or c) worn oil pump, and/or d) increased bearing clearances.

You either have water in the fuel storage container and/or the tractor fuel tank That will allow bacteria to grown in the fuel as it lives in the fuel/water interface. When you use BioKleen it will kill the bacteria but you still have to deal with bacteria and its waste. It doesn't disappear.