imnukensc's latest activity
-
Iimnukensc reacted to North Idaho Wolfman's post in the thread BX23S Power Steering "Bump" with
Like.
Its all run by the same pump, so yes quite normal to feel other hydraulic systems coming to an end point of their stroke. -
Iimnukensc reacted to Runs With Scissors's post in the thread M135x red warning light, incorrect temp reading with Like.
You sir are a fantastic source of knowledge in many areas, and I tip my hat to you. However, I am the Darth Vader of "bar fights/potty...
-
IMine was was very difficult to open until I figured out pushing down on the hood and then sliding the lever was a game changer. Opens...
-
IA VPN is an end to end encrypted data channel that prevents intermediaries on the internet from seeing the contents of your data packets...
-
Iimnukensc replied to the thread Putter geeks.I thought this was a golf question.......which I can't help with either.
-
IAfter buyiny my B2320 it came with a FEL but no mower. couldent get a MMM so after help and advice from all the helpful folks on this...
-
Iimnukensc reacted to JasonW's post in the thread A HST oil change gone wrong, what would you do? with Like.
Two drains under the engine would be for engine oil. You must mean the two under the Transmission? These scenarios only work if the...
-
II agree. I blow out the radiator screen every time I cut the grass with my BX It always has clippings and dust in it. Air intake...
-
Iimnukensc reacted to North Idaho Wolfman's post in the thread 1998 L3010 Three Point Hitch Questions? with Like.
There is a set of washers and spring washers that keep the lever from "just falling". Loosen the outside lock nut (#130) while holding...
-
Iimnukensc replied to the thread When did they change the lettering?.They probably changed it because of all the idiots that don't know how to spell Kubota, but I don't think it will help.
-
IHmm. I surf what I want on YouTube with no problem, no ID, nothing required.
-
IRaise the tractor up, turn the blades by hand from below the deck. You probably have a blade contacting the lip at the bottom of the...
-
Iimnukensc replied to the thread Replacing blades on a RCK 60P 400Z.Yes! Sorry about that. I'll go edit.
-
IDid you mean to type 1 3/16"?