Recent content by G8037

Butch, do you have information on the Metric U-joints? Numbers where to get them? Thanks

Vic, b7800 hst 4x4. Rattle at idle, doesnt matter in 2 of 4 wd. I believe noise comming from 1 or both drive shafts. One has maybe a 1/4 in end play, and I can see the universal coupleing a bit loose where the roll pin attaches to the universal coupleing. Is there a way to remove the driveshaft...

Ok, thanks, Im hopping that is not the case. I discovered in a video on a 7200, i believe, and in that video where they were replacing he throw out bearing, there was a reference to an access hole on the tractor frame that would allow you to locate a grease zerk that would grease the bearing and...

I recently had an expensive 4WD trans repair, all new gears, bearings, and a new 4x4 / 2 WD shift lever replaced. When I got the repair back all was nice and quiet , ie no trans gear rattle noise. Its been about 5 months since the repair, and now starting to get a loud rattle at idle from the...