Recent content by craig68

I've been unable to locate the wiring diagram for the cab. The fuse, #18, is good. There is power to the column switches to light the switch but no other power.

Thanks ACDII Correction, it is fuse 18 Your reasoning makes sense for the after market cab.

I checked both light switches in the column and no voltage found. The wires go up the column. There is a wire harness on each side of the tractor under the floor mat which join together at the fuse block. No sign of any plugs. 14 degrees this morning.

No work lights front or rear on L4060 cab. Fuse 17 is good. It's 15 degrees outside and I don't feel like hunting. I assume there is a plug between the tractor and cab. Is any one familiar with the electrical system who can tell me where to check?

Tire repair companies detest the use of Slime

I just went through that problem on a L4310. Turned out to be the timer relay.

Thanks for responding. I found a bad ground and a bad fuse that did not look bad.

After working on glo plug problem I now have no rear lights or flashers. I'm thinking I pulled a plug loose in dash but can't find problem. I can hear the turn signal flasher working. I found a number of diagrams online but they are incomplete, not for correct model or poorly marked. Have...

Are there any instructions in the WSM manual to access the loader valve? It looks like a bear of a problem.:eek: All help appreciated.:)

My thanks to Bruce and Dave. The problem appears to be wiring. Found the poor connection.

I have a L4310 and when I turn ignition switch to preheat the glow plugs, the dash light flickers and goes out and a relay chatters. I replaced the glow plug relay and the timer relay and they did not help.:confused: Any help appreciated.:):):)

L3410 The change air filter came on and I changed the dirt outside filter. However, the light stays on.:( Anybody know why? Thanks to all who help.