Recent content by Bertrrr

This machine will start with the shifter in neutral , as soon as I move it to either Forward or Reverse it dies right away , if I run 12 volts to the hold in coil , it runs fine no chattering but also no safeties in service I've pulled the shifting safety off to inspect , there are no bad wires...

I can run a hot wire to the solenoid but am being told there are 2 different circuits to the solenoid , one to pull in the coil and another to hold until stop signal

Looking for the OPC timer on my L3830 and a test procedure if you can share it would be great , thanks in advance

Is there a part number for the OPC timer ? My unit is doing the same thing , A wiring diagram would be helpful also if any has one available , thanks

Machine dies after a minute or two , you can hear the fuel solenoid clicking off and on The solenoid has been changed as well as the ignition switch , Tested the seat switch safety and eliminated that part and it still does it , pulled the fuel solenoid and verified the coils read ohms and...