007kubotaguy's latest activity
-
the linkages all lubed up seems to work OK now thanks Hank -
Skeets, thanks for the well wishes. With gas at $2 a gallon I'm going up to Minneapolis and open a day care. I'll be prosperous for sure!
-
Wish to my Orange brothers and sisters,, May the new year by a joyous and prosperous one for each of you
-
007kubotaguy replied to the thread L185 rear brakes.This is a very common problem with these older machines. The brake actuator shaft that goes to the housing has an o-ring on it about a...
-
007kubotaguy reacted to North Idaho Wolfman's post in the thread L3800HST TLB has me puzzled over engine shutting off. Any help would be greatly appreciated. with
Like.
HST, seat switch, or OPC is intermittently cutting the circuit. -
007kubotaguy reacted to Russell King's post in the thread L3800HST TLB has me puzzled over engine shutting off. Any help would be greatly appreciated. with Like.
There is probably more than one safety switch on that tractor. Most likely it is the operator presence switch at the seat. There may...
-
Completed the tank repair today by installing the liner paint. It went well and is curing for the next four days then I can fill it...
-
007kubotaguy replied to the thread M8030DT Hydraulic Filter.As Wolfman said there are two different filters. The early M8030 had a single hydraulic pump and used a smaller filter. The later...
-
007kubotaguy reacted to D2Cat's post in the thread L3130 died while driving, now cranks but no start with Like.
Do you have air in the fuel system somehow? If you insist on using starting fluid never spray it until the engine is turning over, and...
-
@Russell King is not the owner of salvage yard, he was just nice enough to give you a link to a unique salvage operation, very few even...
-
Merry Christmas all.... and really, let's strive for peace on Earth.
-
Contact this salvage yard http://www.mossycreekoutdoors.com/
-
A blast from the past for those old enough to remember
-
Hello all! Hey I'm hopeful to find this 38520-43460 bevel shaft for my L345DT it would make a great Christmas present! Please let me...
-
007kubotaguy reacted to North Idaho Wolfman's post in the thread BevelShaft needed L345dt!!!!! with Like.
Send @007kubotaguy a message he might have or know where to get one.