How to remove pulleys on a RC48-G

3

300zx

New member

Equipment
1979 B7100D, 2009 ZG20, 1991 B2150, 1990 B6200
Dec 1, 2010
445
1
0
Forest, VA
It is time to clean up the deck for the G5200 we bought for my Grandson. I have everything off of it but the outer spindles. It will get sandblasted tomorrow and then on with the weld repair on the holes in the top of the deck. So, how do I get the pulleys off so I can remove the bolts holding the spindle casting? From the parts diagram, it looks like my only choice is to drive the keyed shaft out of the pulley. What I don't know, is if I drive it out, will the key hit the upper bearing and stop it. Anyone have experience with it?

John in VA

 
Last edited:
B

Big Kahuna

Member

Equipment
Kubota 2000 L3010 HST with Loader ,1992 B7100HST , 1979 B6100E & 2007 F2880
Dec 23, 2011
357
6
18
Homer City, Pa.
No you don't have to remove the feather key, but I usually do so I don't loose it, the key is for the pulley, not the spindle as the pictures below will show.

Big Kahuna
 
Last edited:
3

300zx

New member

Equipment
1979 B7100D, 2009 ZG20, 1991 B2150, 1990 B6200
Dec 1, 2010
445
1
0
Forest, VA
Big Kahuna said:
No you don't have to remove the feather key, but I usually do so I don't loose it, the key is for the pulley, not the spindle as the pictures below will show.

Big Kahuna
Click to expand...
Thanks, I didn't realize the shaft stepped up. As I said, I thought it was the same diameter as the inner race of the upper bearing and would stop the shaft from going very far.

John in VA
 
3

300zx

New member

Equipment
1979 B7100D, 2009 ZG20, 1991 B2150, 1990 B6200
Dec 1, 2010
445
1
0
Forest, VA
The key does catch on the inner race of the upper bearing, so I had to use a narrow drift punch between the pulley inner diameter and the threaded portion of the shaft. After soaking in penetrant all night, the shafts finally came out of the pulleys and I got the spindle castings off!

John in VA
 
B

Big Kahuna

Member

Equipment
Kubota 2000 L3010 HST with Loader ,1992 B7100HST , 1979 B6100E & 2007 F2880
Dec 23, 2011
357
6
18
Homer City, Pa.
Like I said I take the dang little thing out because losing it sucks.
I'm tearing down a RC60-71B right now, hope the weather holds with me till after gobble day and I get it painted.


Big Kahuna
 
3

300zx

New member

Equipment
1979 B7100D, 2009 ZG20, 1991 B2150, 1990 B6200
Dec 1, 2010
445
1
0
Forest, VA
Big Kahuna said:
Like I said I take the dang little thing out because losing it sucks.
I'm tearing down a RC60-71B right now, hope the weather holds with me till after gobble day and I get it painted.


Big Kahuna
Click to expand...
I know what you are saying, but I couldn't get the key out. It was stuck in the pulley. So my only choice was to drive the shaft on down, leaving the key in the pulley until the pulley was loose. Then the key came out with the pulley.

John in VA
 
You must log in or register to reply here.

Top Bottom