stuck in 4wd

[HC11]

I have tried everything I know to do. I am not new to tractors. Went forward backwards, turned wheels, lift front end off ground. New kubota 6000----- I guess the next thing will be to lift rear end off ground

 

[jimh406]

Try changing the drive mode to N if that is an option. Don't forget to use the brakes if you switch to N. Otherwise, you might roll.

 

[HC11]

I went out and tried that no luck. I went through low,
med, high, neutral still wouldn't come out.

 

[skeets]

Some times, if you just put light pressure on the tram while you are trying to get out of 4WD it works,, only light pressure on the tram or it could be frozen linkage

 

[JimmyJazz]

if its new it sounds like the dealers problem.

 

[airbiscuit]

I have tried everything I know to do. I am not new to tractors. Went forward backwards, turned wheels, lift front end off ground. New kubota 6000----- I guess the next thing will be to lift rear end off ground

It sounds like you are trying the usual fixes. On my New Holland shuttle, I'll put push the clutch in while I'm still going forward and pull up on the handle. Also, my lever is kind of stiff. I need to pull up on the handle sharply (give it a snap).

 

[HC11]

Mine is a hydro

It sounds like you are trying the usual fixes. On my New Holland shuttle, I'll put push the clutch in while I'm still going forward and pull up on the handle. Also, my lever is kind of stiff. I need to pull up on the handle sharply (give it a snap).

 

[airbiscuit]

You can still pull up on it sharply!

 

[HC11]

You can still pull up on it sharply!

Mine to get out of 4wd you push down and I don't want to break something. The dealer is coming out to look at it first of next week. If he can't get it out they will take it to the shop. I do have a good dealer

 

[airbiscuit]

Let us know their "trick"

 

[Hkb82]

I’ve got a feeling the trick might be preformed at their shop.

 

[North Idaho Wolfman]

There isn't a whole lot to that system.

 

[HC11]

I hope it is something simple

 

[GreensvilleJay]

curious, does the lever move 'freely' or some resistance ?

looking at NIW diagram, if it' free', then I suspect roll pin #060 is busted ?