l2195 Snowblower Repair questions

[mtnplower]

I was running the blower the other week and sucked up a river rock. The rock caused the chain to pull forward ripping the driveshaft out of the bearing.

I ordered this bearing, Part # #77700-00959 ..

I removed what is left of the old bearing and began to look at the new bearing

the issue is the driveshaft part # 70000-02649 does not slide into the bearing.

The driveshaft has a much bigger diamater


Are there different bearing diameter options or different driveshaft options I need to look up?

 

[North Idaho Wolfman]

There is three different versions would need the serial number to tell you which one you have and what you need.

 

[North Idaho Wolfman]

Can't help you without a snow blower model number.

You can't read the title?
l2195 Snowblower

 

[Dustball]

The 77700-00959 bearing should be 1-1/8" ID. What is the OD of the drive shaft?

 

[Dustball]

You can't read the title?
l2195 Snowblower

You need to relax and not pounce on every minor mistake. I deleted my post before you even completed your criticism.

 

[North Idaho Wolfman]

You need to relax and not pounce on every minor mistake. I deleted my post before you even completed your criticism.

WELLLLLL EXCUSE ME!

That was pretty uncalled for!

 

[mtnplower]

There is three different versions would need the serial number to tell you which one you have and what you need.

I didn't know there were different versions The serial number is 21113021

 

[North Idaho Wolfman]

Well all of the sub models took the same bearing, 1/ 1/8"
So like Dustball said, what is the size of the shaft and is it possible the shaft end got damaged when it came apart?

 

[mtnplower]

I ordered the bearing flange and I'm ready to install everything back in

Can the bearing flange be installed first onto the driveshaft and then slide it All in or what's the best method to put it all back together?