Does my tractor have an oil filter? I want to change the engine oil. My manual doesn't mention one.

Russell King

Well-known member
Lifetime Member

Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
Jun 17, 2012
5,356
1,412
113
Austin, Texas
3 point hitch should always be able to lift more than a fel on a tractor.
 

GeoHorn

Well-known member
Lifetime Member

Equipment
M4700DT, LA1002FEL, Ferguson5-8B Compactor-Roller, 10KDumpTrailer, RTV-X900
May 18, 2018
6,039
3,316
113
Texas
View attachment 51976

This was about the limit I think. Pine stump. I could only lift it about 4 inches off the ground for transport but I didn’t need to drag it…using my clamp on bucket forks...
Of course a LOT of that Pine Stump weight is WELL FORWARD of the pins/pivot point of your loader,... If that weight was much closer the performance would have been considerably improved. (But you know that...I’m only making the comment for new folks to consider.)
 

Henro

Well-known member

Equipment
B2910, BX2200, KX41-2V mini Ex., Beer fridge
May 24, 2019
5,781
2,965
113
North of Pittsburgh PA
Of course a LOT of that Pine Stump weight is WELL FORWARD of the pins/pivot point of your loader,... If that weight was much closer the performance would have been considerably improved. (But you know that...I’m only making the comment for new folks to consider.)
Of course, but it was still pretty big! ;)
 

BX23S-1

Active member
May 29, 2017
540
201
43
No where Special
Of course, but it was still pretty big! ;)
Wowww, no doubt, that was a big one! I`m actually surprised you could actually lift it!

I can dig them out with my little (BX23s) tractor, but then i have to make the hole into a ramp so that i can drag and roll them up an out... no way a BX is going to lift big stumps...lol.