B2650 Rear remote Hydraulic tilt

[Fluke631]

After reading online about hydraulic systems, I assume that my backhoe is the last item in the loop (only one line coming out of it) so it goes to the tank.

So when my backhoe is not on tractor my valve power beyond will go on that return line. I read the return lines were only low pressure. Am I going to break something by hooking up my power beyond to the return line?

Thanks

 

[North Idaho Wolfman]

After reading online about hydraulic systems, I assume that my backhoe is the last item in the loop (only one line coming out of it) so it goes to the tank.

So when my backhoe is not on tractor my valve power beyond will go on that return line. I read the return lines were only low pressure. Am I going to break something by hooking up my power beyond to the return line?

Thanks

Negative, the BH is a PB loop not a tank/ return line, it's completely differnt.

 

[Fluke631]

Negative, the BH is a PB loop not a tank/ return line, it's completely differnt.

Great, thanks.

So where do I send my valve return line then?

 

[Fluke631]

Just figured it out!

 

[North Idaho Wolfman]

Yep that line is where you tee the return to.