Hi All, New owner here. I have a L3250. Looking from the rear of the tractor , I have one Hydraulic point on the right hand side and two on the left. Would anyone know if any of these valves are the return or do I simply drop the line in the filler point? I have a 3 point backhoe I wish to attach. Thanks in advance.
Kubota L3250- Hydraulics return
- Thread starter Stubbo
- Start date
rbargeron
Well-known member
Lifetime Member
Equipment
L5450, L48, L3250, L345 never enough attachments
The connectors on the left may be supply and return for an aux valve beside the seat. Where do they connect on the tractor ?
I will take a good look as soon as I can. The auxiliary lever makes sense. Ther is what i assume to be one by the seat. Thanks for the advice and I will, no doubt, ask some more questions when I have inspected. Many Thanks
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Word of Caution:
If your going to put a three point BH on it get the top link reinforcing plate!
Not doing that could cost you a ton of money as the three point BH's are notorious for breaking the top of the three point case.
If your going to put a three point BH on it get the top link reinforcing plate!
Not doing that could cost you a ton of money as the three point BH's are notorious for breaking the top of the three point case.
I dont suppose you would have a pic or a diagram of such a thing would you please ?
North Idaho Wolfman, Are we talking about this kind of thing ?
Attachments
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
No that is just an extension, doesn't reinforce the connection point, this is the plate you need.
Attachments
North Idaho Wolfman, much appreciated. Would you have a part number for such a bracket? I am finding pretty difficult to locate parts here in the UK for my L3250. Thanks again!No that is just an extension, doesn't reinforce the connection point, this is the plate you need.
