SolbergDave
New member
Lifetime Member
Equipment
MX5800HST w/LA1065 FEL, Bobcat forks, QH10, RB3784, BB3584, RTA1274
The problem I'm having is my FEL raise and lower are extremely slow. Just under 30 seconds up, just under a minute down. Here's the coincidence: I just installed a 3 station rear remote and a 3 point top and tilt. After the top and tilt cylinders where filled, the hydraulic fluid was low and I filled it back up. Every thing else works fine. Top and Tilt, 3 point up and down, HST tranny, bucket tilt forward and back. When I tilt the bucket while raising and lowering the speed is fine until the bucket hits a travel limit, then back slow again, until I reverse tilt of bucket. FEL drops normal speed when in float position. OK, I suspected air lock so tonight I ran my RPMs up and ran the FEL up and down, sometimes tilting the bucket, sometimes just the FEL. Even if slow the FEL will still pickup the front of the tractor. After at least 20 minutes of this I'm not sure any impact. If its airlock in the cylinders why does if run OK with tilt? HELP.