baronetm
Member
Equipment
L3901HST w/FEL, 3rd fnct. BH77 BH, 5' Bushhog, 6' BBL, 42" Forks, WoodMaxx WM-8H
Since I have gained a lot of knowledge and some great ideas from you guys I thought I would share one of mine. My version of a chain saw holder mounted on my L-3901. Since the placement of the FEL controls prohibits mounting or dismounting from the right side I though it’s a great place to mount a chain saw.
My version is made from Uni-strut components with a wooden sleeve press fit into the uni-strut. This holder easily accommodates a 20 plus inch bar. It is mounted with a Rubber pad between the mounting plate and the floor board using existing holes. I am looking at modifying it by adding an ax holder to the outside and quart size fuel and oil containers on the inside. Sorry the photo orientation changed during upload.
My version is made from Uni-strut components with a wooden sleeve press fit into the uni-strut. This holder easily accommodates a 20 plus inch bar. It is mounted with a Rubber pad between the mounting plate and the floor board using existing holes. I am looking at modifying it by adding an ax holder to the outside and quart size fuel and oil containers on the inside. Sorry the photo orientation changed during upload.
Attachments
-
94.3 KB Views: 1,264
-
95.3 KB Views: 922
-
89.9 KB Views: 991
-
90.9 KB Views: 827