BX2200 stuck in 4WD

[Brycheiniog]

Hi All,

At some point over the past couple of weeks my BX2200 seems to have got stuck in 4WD. The front drive control lever moves positively into each position but the front wheels are still being driven.

Any suggestions?

Jonathan

 

[Wbk]

Have you already tried rocking it back and forth while moving the shift lever?

 

[100 td]

Try reversing in a zigzag fashion on soft ground while selecting 2WD. Check the lever is connecting, and rotating the shaft the same amount as the lever is moving, i.e. check the roll pin isn't broken.
Stranger things have happened, you are definitely using the 2/4 select lever, and not the Hi/Lo or PTO engage lever by chance?

 

[85Hokie]

Hi All,

At some point over the past couple of weeks my BX2200 seems to have got stuck in 4WD. The front drive control lever moves positively into each position but the front wheels are still being driven.

Any suggestions?

Jonathan

If the lever is moving in it's full motion, first check the linkage - possible something came loose, and the lever is just moving without doing anything else. Most of the time, if it stuck, the lever is very hard to move and rocking as was suggested will usually free it up. I hope yours is a simple "pin" or nut has come loose in the linkage.