L2850 V1702 di > V2203 di conversion

[Wild and Free]

Here is the near complete project just installing the loader with help from the B2150.

.

Sent from my iPhone using Tapatalk

 

[Wild and Free]

For anyone who uses facebook here is the finished project and a pic and video of it towards the end of the post.

https://www.facebook.com/permalink....599379&notif_t=like&notif_id=1497035910313006

 

[Darrell S.]

Good job , I really appreciate all the part numbers being posted and the solutions to the problems you have had. Congratulations !!

 

[Wild and Free]

Thanks Darrell.
Not sure if I mentioned it or not but since the new engine had no predrilled port for the mechanical fuel transfer pump and I didn't feel like trying to drill out a hole that big in the boss of the block I opted for an electric fuel transfer pump from Napa. You can see it in the video. I mounted it to an existing bolt hole on top of the intake manifold and it works awesome. Used a fuse tap and spaded into the shutdown solenoid fuse which is hot when the key is turned on and located behind the radiator so only needed about a foot of wire to power it up. It was relocated a bit from what is seen in the video during the wiring and hose reroute to refine and clean up the look a bit just forgot to take a finished pic of it after the fact.

 

[ASTER]

Do you think if your tractor would have been a d1703 it would of been hard to swap...

Sent from my XT1254 using Tapatalk

 

[North Idaho Wolfman]

Do you think if your tractor would have been a d1703 it would of been hard to swap...

Sent from my XT1254 using Tapatalk

Yes it would be hard as the V2203 is a whole piston length longer.

 

[ASTER]

Yes it would be hard as the V2203 is a whole piston length longer.

like busting my cops!

 

[North Idaho Wolfman]

like busting my cops!

Say WHAT???