Recent content by palomar

I saw them on eBay as well, but don't know anything about them. Did you end up buying it?

Hi Steve, Reading through the forums I noticed you own a B1600. I bought a B1600 about a year ago and am very happy with it. I would like to get a front end loader for it. Did you ever fing out which one you have? Thanks Martin.

I would like get a Front End Loader for my B1600. Does anyone know what would fit my tractor? Thx.

Thanks for the reply kuboman. I did put it back. The #18 bolts are tied together with a piece of wire and a lead seal ( #20 on the diagram, kind of like what the power companies used to use on the electrical power meters), that is why I left them alone, but I will try adjusting them. I would...

Thanks for the replies, Crispy, check this out: http://www.youtube.com/watch?v=B0-JRS_cYRY This is a B1600 with the D950 engine, and it idles a hell of a lot slower than mine. I hope some other people with D950 engines chime in with their idle speeds. Bulldog, I made the adjustment at...

Thanks for the reply. I tried it. It did slow down the idle, but it caused the throttle lever and gas pedal to become useless, i.e. if i press the gas pedal or pull the throttle lever the rpm would not increase and the engine would remain idling. I think there must be another adjustment that...

My tractor has the D950 engine, and it idles fast around 1100 rpm. Does anyone know how to adjust the idle speed or have any other suggestions? What is your D950 idling at? I have checked all linkages and they operate freely, no obstructions. I have replaced the governor springs.

Are you saying that they do work when tractor is not running, or that they do not work at all?

I am replacing the governor springs in my B1600 (D950 engine). I received the new springs today and I am not sure how to install them. The smaller spring fits inside the bigger one and they both connect to the speed control lever on one end, and the fork lever on the other. One end of each...

Vic, thanks for the reply and all of the valuable information. Here is a pic of the plastic piece, it is grooved on one side, so its cross-section would be the letter U. One note, I have a B1600 with a D950 engine. My engine seems to idle quite fast, any suggestions there? Thanks...

I ordered a new tach cable for my B1600 as mine was broken. The new cable arrived today, part#67800-55410 (for B8200). In the bag along with the cable there is what looks like a small plastic washer/spacer. Where does the washer go? Thanks

According to the B8200 non-HST operator's manual both A and B are for the hydraulic/transmission oil, there is only one dipstick. C=???

Yeah, I am not sure if they are the same. Thanks for the offer though, I sent you a pm about a few other parts. Thanks

I beleive it is the PH7328. Use the correct weight of oil (usually written on the oil cap) I dont think it matters which brand.

What engine does your B7100 have?