New profile posts

I was browsing and see you offered a very good explanation of the OPC timer. and hope you could provide some insight with my issue. The L3400, is having an intermittent engine stop. The engine may run 10 seconds or 5 minutes, and can't see any pattern to the length of time before shutting down. Checked the fuel stop relay and it is good. I had to move the tractor out of a flood area so we ran a jumper to the fuel shut off solenoid from the positive battery terminal and had no issues. Figured it must be the OPC timer and opened the dash. We hear the fuel solenoid click and found the glow plug relay would click at the same time. Does the OPC timer control the glow plug power as well as the fuel solenoid power?

Thank you for any insight you may provide. The local Kubota dealer isn't much help with this question so I am hoping somebody may have the info I need.

New member here. Aiken SC & Lincolnton Ga. L4802HST

LX3520 HSDC

New old Kubota B6200 ser#B6200D62591 D850
FEL: B1630

Looking for any information on RW30. Parts manual, workshop manual?

I've been a member here since Nov,2010

Wanted to respond to a question you had about my 3rd gen bucket if you're still curious. The 3rd Gen bucket added "High Dump" bracket to give it better dumping capabilities. The 2nd Gen was a complete redesign of 1st Gen to make it less expensive to build.

need help with my gr2100 snowblower

I have a B2630 I purchased new in 2011 the receiver end of the seat belt quit holding the ratchet in place I can hear it snap in place but a nice tug and it pops right out.
I am looking fo a replacement receiver end.

Find a snow blower for your B7800?

Where can I find a cheaper alternator for my BX23S. I only see them for $350

would you like to sell your L48. David 310-625-6534

very nice machine!!!

Kubota u173a. 2012
All works ok apart from arm and tracks which I assumed was a faulty safety switch, I have checked this and all is ok, If I give it full revs I get minimal track movement and arm movement, I have removed the hydraulic pump and spline etc all intact so could it be the solenoid off the safety switch? If so where would that be located? I would very much appreciate any advice
Regards

I have an L245Dt and I am looking for the left side axle. My manual has a part number of 35110-2711. Does anyone out there have a used one for sale?
Thank you!

Kubota u173a. 2012
All works ok apart from arm and tracks which I assumed was a faulty safety switch, I have checked this and all is ok, If I give it full revs I get minimal track movement and arm movement, I have removed the hydraulic pump and spline etc all intact so could it be the solenoid off the safety switch? If so where would that be located? I would very much appreciate any advice
Regards

I have a Kubota B2400 it is loosing power especialy in high gear I have changed fuel filter, fuel pump both new injectors, checked the timing gears, but does not have enough power when driving, will stall out without a strain, could it be hydraulics, i have the kubota servic manuals but can not figur it out, any help would be appreciated thanks

Hi Fried, Thanks for various helps online.

Saw you have Fords and an 8N. Here's a photo I took 4 years ago as my friend Buck Spooner down the road finished a restoration for a customer:


Regards, Terry

Tractor is in 27527 zip, Archer Lodge, NC. Raleigh area.

hello to anyone who might own a G6200 kubota with a 3 cylinder
it stop running and cannot move it other than lifting the rear end off the ground
does anyone know if that 1989 has a nutural gear to be pushed
sure help if i can find that out
thank you all that reading this