Latest activity
-
007kubotaguy reacted to TheOldHokie's post in the thread B7800 front axle ball bearing question with
Like.
I designed and manufacture a hydraulic pump for old Ford tractors. I buy Koyo bearings "in bulk" frim MRO Supply. The bearings are drop... -
torch replied to the thread B7100 Piston Installation.There are Schrader valves and then there are Schrader valves. Well, different valve cores anyway. Compression testers should be fitted... -
RrScotty replied to the thread bucket tilt.It sounds like you have one set of lines to the new bucket cylinders reversed so that they are working against each other. Consider...
-
Nnumber two reacted to TheOldHokie's post in the thread Front end loader control valve leaking with Like.
Kubota online parts shows the L1730 loader in the related units list for a L245. Does the diagram below look fami⁹liar? Look the...
-
Nnumber two reacted to Trash Panda's post in the thread Front end loader control valve leaking with Like.
If you’ve got a hydraulic shop within driving distance, most of them can simply rebuild things like that with parts they have on hand...
-
RRussell King reacted to NickAdams's post in the thread B2400 HST 4wd - Partially stripped bolt housing with Like.
The Loctite 545 Automotive Pneumatic/Hydraulic Pipe Thread Sealant Purple failed immediately. Brought the tractor to Woodstock...
-
Nnumber two reacted to tshep's post in the thread BX23 startup after head gasket, 740 hours, 22 years old with Like.
Well, you don't. I thought I would finally use the 9/16 'crow's foot' 'wrench" that was in my 1975 graduation tool set - it slipped. So...
-
NFor the third time - what lever are you using to operate the 3pt? Dan
-
@JohnR68 If you have some sort of lift pump involved (tank mounted low) then that is probably failed. When tank is fuller there is... -
You could bypass the fuel tanks with a small test fuel tank that would provide unrestricted fuel flow.
-
junk in tanks.... it is 12 years old.... parking brake kinda on
-
I have a 2013 ZD326s with ~1500 that is bogging down under load. It starts and runs great in place, no smoke, no misfiring. It will...
-
NLooking at Messicks illustrated parts list I found this Looking on the internet I found this more descriptive name = you may have...
-
NSelkirk_D, thanks for the input. I have a new Kumar Bros. head complete with valves, springs, etc. and I lapped the valves when I...
-
BBFarmer replied to the thread What's cookin' boys?.Standard requirements for an alice springs chicken....... going to do some roasted/smashed baby yukons with it. Last pickers of the... -
