Hey, first time poster. I’ve got v3600-eu2 kabota that runs a built-rite processor ((cord wood machine) operate at about 2000rpm. Was running it today and it bogged down over about 5 seconds brought itself down to idle (500rpm) wouldn’t rev back up.. Pulled the air filter, changed the fuel filter, oil change ( wasn’t low on oil) nothing has helped so far.
V3600-eu2
- Thread starter Joytide
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Is it equipped with a turbo?
Have you checked for fuel flow though out the system up to the injection pump?
Have you checked the air intake filter?
Have you checked for fuel flow though out the system up to the injection pump?
Have you checked the air intake filter?
Non-turbo, Im pumping fuel through the fuel pump. Have a new fuel filter on it. Pulled the air filter out ran it and saw no difference.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Pull the fuel line directly at the injection pump and bottle feed the injection pump just with gravity from above it and see what you get.
Does the stop solenoid internally or externally control the injection pump?
Might need to remove it and see how it runs with it out of the equation.
Are you 100% sure the fuel is not contaminated with something like gasoline?
Does the stop solenoid internally or externally control the injection pump?
Might need to remove it and see how it runs with it out of the equation.
Are you 100% sure the fuel is not contaminated with something like gasoline?