Rubber or Poly Cutting Edge for Kubota V 5060 Plow

[SDT]

I would like to replace the steel cutting edge on my Kubota V 5060, 60" snow plow with a hard rubber or poly cutting edge . This plow is used on my Kubota RTVX-1100C.

Kubota does not offer a rubber or poly cutting edge for this plow.

The OEM edge is 1/4" flat steel 72" long X 6" wide and is held in place by 8, 5/16" carriage bolts.

The plow is made for Kubota by Curtis Industries.

Anyone know where I could find one?

SDT

 

[sheepfarmer]

There are a number of commercially available softer plow edges, some are quite pricey, but engineered for commercial use like plowing hospital parking lots. They will cut to your specs. My solution was 5/4 plastic deck board, can be cut and drilled to fit. Will wear and might break if you whack something, but that might be a good thing. Mine has lasted through 3 winters so far. Cheap/free.