Hi,
I'm thinking about getting a hydraulic valve kit for my b2601. The main reason for this is so that I can borrow my neighbour's concrete mixer. That reason alone does not justify the cost of the kit IMO. But I'm thinking I could buy a cylinder and hook it up on by backhoe thumb. And in winter, I'd remove the cylinder from the backhoe and hook it up to me snow blower chute. Not sure If I could reuse the same cyl but worse case I'll just buy 2.
So my question is: am I right into thinking that I can just buy a cylinder and hook it up to a thumb or to the blower's deflector? or does it get more complicated than that?
I'm thinking about getting a hydraulic valve kit for my b2601. The main reason for this is so that I can borrow my neighbour's concrete mixer. That reason alone does not justify the cost of the kit IMO. But I'm thinking I could buy a cylinder and hook it up on by backhoe thumb. And in winter, I'd remove the cylinder from the backhoe and hook it up to me snow blower chute. Not sure If I could reuse the same cyl but worse case I'll just buy 2.
So my question is: am I right into thinking that I can just buy a cylinder and hook it up to a thumb or to the blower's deflector? or does it get more complicated than that?