Help! I have 20 year old L2900 with FEL, everything fine until a hose blew. lost a lot of fluid. replaced hose and fluid and filter. tractor runs but zero lift on 3 point and FEL only goes down with 'float' position and jerky lifting of bucket, steering a little jerky too?? there was zero problems before fluid leak.
L2900 3 point stopping lifting
- Thread starter DrBruce
- Start date
Please advise exactly which L2900 you have as there are several models.
Typical symptoms for hoses put on in wrong places. I am guessing to replace one you removed more than one!
Are there 7 hoses on your loader?
Do two of these 7 attached to a hydraulic block on the tractor?
Clean up the valve body of the loader valve until you can see letters cast into the body near certain ports.
These letters will be a good starting point.
What model is your loader? Is it the LA481?
In the above block detail page it is often the A and B hoses in the wrong place.
Dave
Typical symptoms for hoses put on in wrong places. I am guessing to replace one you removed more than one!
Are there 7 hoses on your loader?
Do two of these 7 attached to a hydraulic block on the tractor?
Clean up the valve body of the loader valve until you can see letters cast into the body near certain ports.
These letters will be a good starting point.
What model is your loader? Is it the LA481?
In the above block detail page it is often the A and B hoses in the wrong place.
Dave
Last edited: