L-285 charging system
- Thread starter harleysnake
- Start date
Nobody has jumped in here; let me say that I do not know specifically.
This is how I would go about finding it if it was my tractor. Look at the battery + terminal, is there a wire built into the clamp on that terminal? is so it is usually goes a few inches and has the fusible link plugged into that. No wire on the + clamp? Go to the starter motor; on the large terminal holding the cable that comes from the battery there is a smaller wire, that is the one to follow. wipe the dust and smoodge off it and identify the color(s) black w/red stripe maybe. Follow that as far as you can go; if it disappears into a harness follow that harness, see if the wire comes out a short ways from the starter. It will come out, into a 2 pin connector that has the other (male) side of the connector with a simple loop in it, then right back into the harness. That male plug with the loop is the fusible link, pull it out, check with ohm-meter, plug in new one.
This is how I would go about finding it if it was my tractor. Look at the battery + terminal, is there a wire built into the clamp on that terminal? is so it is usually goes a few inches and has the fusible link plugged into that. No wire on the + clamp? Go to the starter motor; on the large terminal holding the cable that comes from the battery there is a smaller wire, that is the one to follow. wipe the dust and smoodge off it and identify the color(s) black w/red stripe maybe. Follow that as far as you can go; if it disappears into a harness follow that harness, see if the wire comes out a short ways from the starter. It will come out, into a 2 pin connector that has the other (male) side of the connector with a simple loop in it, then right back into the harness. That male plug with the loop is the fusible link, pull it out, check with ohm-meter, plug in new one.