I had to do a complete tear down on my B7610. Water got into the oil. I got everything put back together and had to redo because of a timing issue. It would turn over, just not start with white smoke coming out of the exhaust. I reset the timing and came back to turn over and now I have nothing. There is no power at the dash, no fuel solenoid click, nothing. I have replaced all fuses, replaced 30a slow burn fuse., and checked to make sure all grounds were bolted up. I have 12v at starter and starter solenoid when turning the key. There is power in the harness at the dash. Any help would be greatly appreciated.
I have no power
- Thread starter zipper8069
- Start date
Russell King
Well-known member
Lifetime Member
Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
Sounds like a bad battery or bad connection between tractor and battery. Try cleaning the battery posts and terminals as a first step. Then try jumping with a known good battery.
A flat 12 volts may not indicate enough voltage and amps to get you going. You can have the battery tested at auto parts store.
Sometimes the battery cables have degraded internal to the insulation and can’t pass enough amps to crank.
A flat 12 volts may not indicate enough voltage and amps to get you going. You can have the battery tested at auto parts store.
Sometimes the battery cables have degraded internal to the insulation and can’t pass enough amps to crank.
