Hydraulic Chute Elevation on a BX2822

[DustyRusty]

This is a continuation of updating the chute on my old BX2616 Snowblower Click here to view the old thread. I reused the old hoses that were already attached to the cylinder that I sourced off of a rusted-out Kubota snow plow. Those hoses were a bit short, so I ordered new hoses at 120 inches, which I figured to be the correct length. They turned out to be a bit long, but it was easy to take up the excess by creating a larger loop at the top of the chute. When the chute is turned to the extreme right, the hoses no longer are binding, and going to the extreme left, they are correct. The pictures below should be self-explanatory, however, if you have any questions, please post them to this thread. I am hoping that this will help others that want to tackle this same project in the future. The third function valve is by LandPride specific to the BX23S