DIY front brush guard

[asgard]

Just finish my front brush guard, it is made from tube and all the sections are doubled up with a tube inside a tube.

As I only use my tractor for cutting grass, blowing snow and some lifting and carrying no forestry work I thought this might be enough.

I made it so it tilts forward for hood access, I was going to make it so it went straight out and maybe use the platform for a light loading - still could but decided to get or make a carrier that would fit into the receiver.

I suppose it has enough strength for my purpose and being tube it is a different look to stock.

 

[Steve67]

Nice job, really like the look!

 

[skeets]

Looks like you could run over mooses with that,,lol,,, A very nice job

 

[Yooper]

Very nice! What did you use to form the tube and fish mouth the ends?

 

[rkidd]

Very nicely done. Looks really sharp!!

 

[Redtoorange]

Man o man there are some talented people on this site. You do better work then most factories.


Sent from my iPad using Tapatalk