class 1 to class 2 three point hitch pins.

[Josef]

I have a class 1 shredder but a class 2 three point hitch. I was told by an old farmer that I need to buy a pin that is class 1 to class 2 without using adapters. I haven't had much luck finding 1 on the internet so far. Is this good advice and if so where would I find 1.

 

[Dr Honda]

At the local far store... they have a slide over bushing for a few $$. I think that's what you want. But... they also sell class 2 pins. (you can just swap them with your class 1)


If you have a TSC close... look there.



http://www.tractorsupply.com/tsc/product/countyline-category-2-to-1-lift-arm-bushing?cm_vc=-10005

 

[Daren Todd]

Tractor supply usually has a pretty good assortment of pins.

 

[CFDWheeler]

You will still likely need a bushing for your top link pin unless you enlarge the holes on the implement.