BX25-Where did you mount light switches?
- Thread starter Flienlow
- Start date
I put two led spots up under the top of the rops, and wired them into the handy spare connector in the rear that is hot while the key is on. The draw is pretty slight, and it's handy to just turn the key and have light while starting the tractor. They really make using the loader at night much better.
Jerry
Jerry
That looks great! If I ever get around to adding rear lights I think I'll look for switches like yours.
Jerry
Jerry
I have switches on the lights themselves at first (still have them there), but I finally installed an overhead console (hard cab) and have all the switches I could want.
Before the hard cab I just switched the lights on at each light
Before the hard cab I just switched the lights on at each light
Did you get those lights on Amazon? They are usually the cheapest. What's the part number. Still waiting for the second week to get my tractor, bummed. I want to do a set up like you did. Looks great!
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
I just went for ease and simplicity.
Lights: (they come as a pair with mounting brack)
http://www.amazon.com/gp/product/B00NIHOZP8?psc=1&redirect=true&ref_=oh_aui_detailpage_o02_s00
Switch Harness: you will need extra wire from auto store to extent. I just bought these for the relay and switches for the most part.
http://www.amazon.com/gp/product/B00O72R7Z8?psc=1&redirect=true&ref_=oh_aui_detailpage_o02_s00
ROPS mounting: Not sure if these are the exact ones, but very similar. I just wrapped the with electrical tape and sandwiched them on.
http://www.tractorsupply.com/tsc/pr...-2191bc-5-16x2-u-bolt-plate-zinc?cm_vc=-10005
Hope this helps.
Lights: (they come as a pair with mounting brack)
http://www.amazon.com/gp/product/B00NIHOZP8?psc=1&redirect=true&ref_=oh_aui_detailpage_o02_s00
Switch Harness: you will need extra wire from auto store to extent. I just bought these for the relay and switches for the most part.
http://www.amazon.com/gp/product/B00O72R7Z8?psc=1&redirect=true&ref_=oh_aui_detailpage_o02_s00
ROPS mounting: Not sure if these are the exact ones, but very similar. I just wrapped the with electrical tape and sandwiched them on.
http://www.tractorsupply.com/tsc/pr...-2191bc-5-16x2-u-bolt-plate-zinc?cm_vc=-10005
Hope this helps.
Picture is fuzzy but I mounted two switches right next to handle on left. Very convenient. One switch handles two forward facing floods. The other handles one rearward and one forward Spotlight.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Last edited: