Well I screwed up and had to replace the PTO selection gear shaft in the transmission on my bx2380. What a job. Split the tractor and took apart the transmission. While I had it all apart, I was digging for the metal chunks and found a small spring and ball in the bottom. Best I could think of is that this is a pressure relief somewhere. However none of the diagrams show one in the pieces I disassembled to do this job. Any ideas where it might have come from?
Mystery small spring and ball in bx transmission
- Thread starter idiotdiy
- Start date
whitetiger
Moderator
Staff member
Equipment
Kubota tech..BX2370, RCK60, B7100HST, RTV900 w plow, Ford 1100 FWA
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
That is not a pressure relief spring or ball, they look different than that.
That is a detent spring and ball.
That is a detent spring and ball.
Where in the trans-axle? I didn't take apart anything in the lower portion of the transmission (the axle). I only did the front and back plates. I can't find a diagram showing any of these in the transmission anywhere. The only springs I found in the diagrams were on the hydro pumps.