B6000 bottom bracket for 3pt hitch

[smartz]

New to the Orange tractor Talks,
I am testing the waters.
Can anyone help me with the lower brackets on a B6000?
I am looking to fabricate the ears that attach the arms of the 3pt to the gear case of the tractor. I have an aftermarket 3pt hitch kit but need the dimensions to the plates to mount it up. This tractor has the rotorvator (factory).

History: I purchased a running 77 , B6000 3 years ago and am slowly rebuilding it. This little tractor impresses me every time I run it. The unit also has a FEL and has proven to be very handy. The plan is to have it handle most of the dirt work on a micro farm in Fairbanks. Spring is here and the ground will be thawed in a few weeks!

Any information would be appreciated,
Thanks,
Steve

 

[Aluthin]

Hi Steve welcome to OTT I have a b6000 I will look to measure it up tomorrow after work for you. I take it you want hole centres and layout. Will do my best.

Sent from my MotoG3 using Tapatalk

 

[Aluthin]

All measurements in millimetres I am no good with inches. Took my bracket off and drew round it. Measurements are as accurate as I could +/- 1mm at most. Hope this helps. If you need angles I can do that.

Sent from my MotoG3 using Tapatalk