B2150, B8200 3pt hitch lower lift/pull arm

[perry]

The part number for the lower lift/pull arm that I need is 67800-71214.
The price for one of these is $255 and I need two. Does anyone know the dimension (center of ball to center of ball on one). If I get this dimension is there any reason I cannot use the lower cost non OEM arms?

thanks
Perry

 

[Bulldog]

The ones on my L 3000 are 27 inches. Hope this helps

 

[perry]

When I compare the $255 OEM to the $29 (most likely india product) arm, I am assuming both are forged (maybe the india products are not forged). If both are forged and if the OEM arm is U.S. made then I expect it to be higher priced but this price difference seems large unless there is some difference in geometery (that requires a special die) other than a location of a hole.

Assuming the pictures in my manuals are drawn to scale I estimate my pull arms to be about 24" to 25".

 

[Eric McCarthy]

Go check out West Kentucky Tractor parts and get you a set used from thier tractor junk yard.

www.wkytp.com

 

[perry]

Thanks for the link.