Adding rear hydraulics on 2003 L3130

[fstrickland]

I have a 2003 L3130 with no loader or rear hydraulics. I am wanting to add rear hydraulics to operate a hydraulic top and side link for a box blade. I have attached 2 pics of the rear hydraulic block under the seat. The only hoses coming off the block is pressure and return for the cylinders on the 3 point lift. I have reached out to Summit, WR Long and Tractor Innovations. All say they have a kit they believe will work but was not sure how to pipe it in on this model. Any insight and advice is greatly appreciated!!

 

[Russell King]

Go to this site and look at the illustrated parts lists

Kubota Tractor Corporation - Illustrated Parts List

- K-PAD - Parts Lists - Illustrated Parts Lists - diagrams

apps.kubotausa.com

There appears to be a few different versions of a “L3130d” so I might be wrong but there appears to be a hydraulic take off block, see picture below. You take the pressure out to your new valve that must have a power beyond sleeve, then from that sleeve you go back to the cover plate tap to supply pressure to the rest of the tractor. You will also have a tank return line from the valve that dumps into a port that goes into the tractor sump.



Then see this thread (post #1) for how replacing the cover will allow tapping into the hydraulic system.

B7100 Hydraulic block diverter (70060-00360 or 70070-00385)

Back in stock. CDN$40 plus actual shipping These are obsolete and no longer available. I have recently been contacted by a member asking if I will make him one of these after reading how I made mine. I know this comes up from time to time and would like to gauge the interest others might have...

www.orangetractortalks.com

 

[Russell King]

See Post #16 in this thread for a description of how a replacement cover was used on my L185 and a picture of the flow out of the cover and back into the cover along with the tank return line.

Rear remote hydraulic on Kubota L245DT

My L245DT has aftermarket power steering..does not have a front end loader. The power steering cylinder is connected to the control valve below the left side of the seat via an aluminum block. How do I do this? Thanks for any help.

www.orangetractortalks.com