My L3301 keeps popping one of the 5 amp ECM fuses when the treadle is engaged. Its most likely a dead short or a bad sensor (?) but I cant find any wiring in or around the treadle. Any suggestions? Could it be something else? The tractor starts an idol's perfectly one and engaged the treddle forward.The feuds , instantly , pops and the tractor stops.
5 amp ECM fuse keeps popping
- Thread starter schnellml
- Start date
Captain13
Active member
Equipment
M7040 4WD ROPS, ZD28, Woods (84” box blade, 72” harrow, 48” pallet forks)
Look for a wiring harness around the treadle linkage. On Non treadle models, the brake and clutch linkages have been prone to chafing and blowing that fuse. If you remove the fuse and use a meter to go from the fuse block where the fuse was to ground and move the treadle, you should see the ohm meter go to 0 ohms when you move the treadle if that’s where your short is. If that’s the case, start tracking that harness and look for a chafed or bare wire that’s being shorted to ground.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
