Just finish my front brush guard, it is made from tube and all the sections are doubled up with a tube inside a tube.
As I only use my tractor for cutting grass, blowing snow and some lifting and carrying no forestry work I thought this might be enough.
I made it so it tilts forward for hood access, I was going to make it so it went straight out and maybe use the platform for a light loading - still could but decided to get or make a carrier that would fit into the receiver.
I suppose it has enough strength for my purpose and being tube it is a different look to stock.
As I only use my tractor for cutting grass, blowing snow and some lifting and carrying no forestry work I thought this might be enough.
I made it so it tilts forward for hood access, I was going to make it so it went straight out and maybe use the platform for a light loading - still could but decided to get or make a carrier that would fit into the receiver.
I suppose it has enough strength for my purpose and being tube it is a different look to stock.
