Front Axle center pin and bushing B7100 HST

T

troge

New member

Nov 30, 2019

5

0

0

Norway

Dec 5, 2019

• #1

What is the easyest way to change the bushings on the front axle senter pin on my Kubota B71000 HST 4x4? Do I need to take out the motor?

 

Last edited: Dec 5, 2019

Lil Foot

Well-known member

Lifetime Member

Equipment

1979 B7100DT Gear, Nissan Hanix N150-2 Excavator

May 19, 2011

7,485

2,492

113

Peoria, AZ

Dec 5, 2019

• #2

Re: Front Axle senter pin and busching B7100 HST

No, lift the front end, support the tractor, and pull the bolts holding the front wheel support frame (#1) from the engine and lower the whole assembly. Then you can pull the center pivot bolt & access the bushings.
A couple of pics from my front axle rebuild- you won't have to teart it down this far.

 

Attachments

• 
  front wheel support.jpg
  87.8 KB Views: 1,305
• 
  IMG_0055rrr.jpg
  79.3 KB Views: 1,230
• 
  IMG_0056rrr.jpg
  74.1 KB Views: 665

T

troge

New member

Nov 30, 2019

5

0

0

Norway

Dec 5, 2019

• #3

Only the radiator that I need to remove first?

 

North Idaho Wolfman

Moderator

Staff member

Lifetime Member

Equipment

L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more

Jun 9, 2013

29,936

6,119

113

Sandpoint, ID

Dec 5, 2019

• #4

troge said:

Only the radiator that I need to remove first?

Click to expand...

You don't need to remove it, just take out the 2 bottom mount bolts and it will stay with the motor.

FYI: The 2 radiator mount bolts have hair pins in them to keep them from coming out, and when you put them back in, don't tighten them more than it takes to put the hair pins back through the bolt, that lets the radiator float a bit.