Search results

Mine is different from that one. I do have a dynamo but its in like an alternator not like the picks in the link. Mine has a water pump also, The dynamo on mine has two wires and as I was testing it showed 30amp ac at 2600-2700 RPM. Is the regulator testable or is it to be replaced when dynamo...

Thanks everyone for the help. After cleaning the strainer 5 times I have lift. Only problem now is no charging. Any trouble shooting tips greatly appreciated.

Thank you Russel for this idea also.

Thank you sir. Yes I want to make sure whats wrong. Don't want to buy when I don't need to. I'll try this.

Where do I find the serial number on this B8200E. I have found the metal plate thats attached on drive side of transmission housing but it doesn't have the serial# on it. It's a 1986 year.

It acts like its sucking air from some where. Probably just gonna get a pump kit, o-rings and seals, and rebuild it. I found out the lift has been inoperable for about a year. It has a finish mower on back and thats all its been used for all its life. Its a bushhog brand finish mower not brush...

I agree it looks simple and there's some little something I'm over looking but can't put a finger on it.

Yes. I removed the "A" port and started the engine and a gush of fluid maybe a 1/2 cup came out then nothing. Shut engine off and repeated with same results.

Well I've done all of the above still no lift. The pump will growl for a second or two and the lift will raise an inch when that happens then nothing for 5-10 seconds then it growls again for a second or two and the lift raises. It will continue this until the lift is all the way up. The...

I drained fluid again and replaced o-rings #8 and hose #3. Strainer was clean this time but did spray with brake cleaner and used air to blow out. Still no lift. The pump sounds like its cavetating. Will replace o-rings #6next.

I ran it to warm up fluid. Drained fluid and noticed the fluid is full of air bubbles. Is this normal and if not where might it be sucking air from? Imp gonna replace the o rings on the strainer bolt and the piece of braided line connecting the two halves of the strainer tube.

Would pouring kerosene through fill port and letting it run out the strainer port be ok? Since strainer is at bottom of reservoir it should clean it out I'm thinking.

Maybe just age and lack of use? The fluid wasn't clear like new fluid ,not dark like dirty, but wasn't milky like contaminated with water either.,

This is a 1986 year model with only 427 hrs. I'm told everything is original.

Ok so I drained fluid and removed strainer and it was clogged with gunk. I cleaned and reinstalled and filed with new fluid. Started tractor and let run before trying lift. It was making a sound that it hadn't been but when I tried lift it tried to raise and stopped. I pushed lever back down and...

Thank yall so much. I appreciate all suggestions. I assume if filter-strainer is clean and no fluid from port "A" then its gonna be the pump.

Hello all, new member needs help. I received a B8200 with 427 hrs from a friend. Its a one owner machine always barn kept since new. The 3-point lift doesn't work up or down. No bucket or backhoe. Have searched internet but can't find out any info on a manual trans machine. I want to start...