Search results

Thank you, I’ll might try that. I have half of the bed frame left.

I almost flipped a chunk of concrete backwards. I understand I was fortunate.

Do you run max air pressure in the front ? My max is 60 psi and I started the R4 out at 50 but I’d like your opinion. Thanks

I tried Discount Tire, no luck. Amazon had R4 with the rim was 300 and change. 160 for the tire only. I purchased both because I destroyed my rim. Now I have R4’s instead of R14. I should have snapped a pic of them mounted. Because the R14 was 1.5 inches taller than the R4. Same exact tire size...

I used a bed frame and a piece of steel grate with my harbor freight wire fed welder to fab this together. Came out pretty good for a beginner. I’m going to add something below, maybe a steel bar across the lower part. Quick unrelated question, does everyone run max air pressure in the front tires ?

I had 60 hours on my R14 before I replaced them. Front only. How many hours did you get on your front tires ? My Amazon options were R4, nothing showed up on R14 search. I see the max pressure is 60 psi. Do you run max pressure ?

Another question is involving the tire angle. Yours looks toed in like mine. Do you need to adjust it to run a flatter R4 ?

Thank you for the advice. I’m new to this tractor stuff. I am an expert on RZR’s and Maverick UTV’s. Tire pressure is always important on where you ride. I should have asked the question before this expensive lesson. I always thought that they over inflated but they were at the max pressure and...

Best news I heard today, I just pulled the trigger on an R4 tire only. So I don’t need to worry about running mismatched tread depth on a 4x4 tractor. Also can you add some insight on tire pressure and the R4 is a flatter tire compared to my more rounded tire the tractor came with. Should I...

L2501 60 hours. I had my first experience with a blowout tire. Sad part was I didn’t know it had lost pressure and I was in low gear rolling slowly and until I turned it was then I noticed the tire almost off or the rim. I went to Kubota and found I needed to buy a tire and rim combo. Well no...

Give these guys a call, I was there last month picking up my tractor and they have (in stock) every type of bushing imaginable.

It looks like there is enough room to move the forks inwards. Am I correct ? Thanks

Thanks for the attached photo. I see it covers the corner pretty well.

Thanks, I appreciate the feedback Thank you for the advice. So it just slips over the front edge and bolts on the sides of the bucket ?

Thanks, I saw the piranha on YouTube. Looked pretty legit.

Much a much appreciated. Thank you

I have a row of holes on the front of the 64 inch bucket. They look factory drilled and spaced. I’m not sure if I should pick up a toothed blade to protect the front of the bucket. I have zero experience, except the 4 hours of seat time. Not including the online research that has me confused...

Thank you