Search results

I wasn't being critical and I know Whitetiger knows about Kubotas. I know nothing about them but I am pretty handy. Just trying to use the WSM and it's not very clear. I don't want to loose the position of the lever completely then it will be an expensive trip to the dealer.

FYI I had the wheel off, twice, the adjustment bolt takes a long extension just to get to it, barely get a finger on it but thanks for your input you clearly don't know anything about it, not sure why you are even commenting.

I appreciate the help, I really do, but no one has explained why the lever does not move after I loosen the bolt like the WSM says. Whitetiger says to move the switch: "Loosen the two mounting screws and see if the mounting holes are slots as the switch could be moved closer or farther from the...

There have been some replies from a couple of different people but it seems nobody has actually done the HST neutral switch adjustment. Have you?

The conversation was about both issues, you replied to my comment about the seat switch and even quoted it. The HST switch contacts a lever that pivots. Manual says to loosen the "one bolt" that is in a slot and "move the lever until the wheel stops." See previous diagrams. Loosened bolt but...

Welded, not adjustable. Forced to jerry rig 3 pieces of mounting tape. I weigh 185 but apparently not enough to make the switch work 100%.

No I'm in the seat when it happens. I added a couple of layers of thick mounting tape to contact the switch, haven't tried it yet. I see where people say to adjust the switch but there is no adjustment. Apparently nobody here has actually adjusted the HST neutral switch lever, I'm going in to a...

Do you know how to adjust it, have you ever done it?

So I greased the treadle pedal zerk under the mat, thankful for the access flap, and shot PB blaster on every point that pivots with the pedal and linkage. It looks like I will have to adjust the neutral position lever on the neutral switch. If anybody has done that some advice would be greatly...

Thanks for the diagram, I'm going to do this today!

I see what you are saying. The WSM is useless on this adjustment, why would it not give more details? It does say to only loosen the bolt two turns so the nut does not fall off the back. Like you are saying, it looks like you have to loosen 2 bolts. Thanks for the advice. I will try this later...

I'm going to do this today and lube other spots with PB Blaster.

I was using the procedure in the manual, see attached. Maybe I'm using the wrong term, it is the "neutral position" as referred to in the manual.

I'm having an issue with my 2022 BX23S with 80 hours. Tractor creeps backward when letting up on the pedal also when jacked up. I've tried the procedure in the manual, jack up tractor, remove right rear wheel, loosen the bolt...but I can't get the bracket to move. What is the trick? I have the...

Engine running, tractor keeps creeping backward when I let up on the reverse pedal. I used the procedure in the manual. Tractor raised with right rear wheel off, axle slowly turns in reverse when letting up on pedal. Manual says to adjust switch until it stops. I loosened the bolt to the point...

Working on a 2022 BX23S with 80 hours. Tractor will not stop when I lift off the pedal going in reverse, forward is fine. I did get a WSM manual and it shows to loosen the bolt on the bracket but is pretty vague on what to do after that. I marked where it is set at, loosened the bolt to the...

Thanks everybody! Checking for spring and ordered a service manual.

New here. I've been tinkering on a BX23s. The hydro pedal does not go back home like a previous tractor I had, in other words, it kind sticks, especially in reverse. Looking at diagrams I do not see any springs on the pedal system. I do see a damper. Is this what makes the pedal go back to home...