Search results

No 2400 I was referring to hydraulic system I guess it was misleading

K will do thanks

Well it's took a little long but here's what I have Cold test Idle pressure 50 Open remote and held 10 seconds 2400 Idle 50 Hot test was all over the place 1st time Idle didn't move the guage 0-5 Open remote valve 2000 held for 10 seconds and it fell to 1000 but then climbed back to 1500 and...

Sounds good thanks

I actually performed this test this morning but cold only and with no weight on the lift arms The test went as follows lift and draft control down no remote connections Cold start was zero and crept to 100psi after about a minute, held remote to full open at 2500psi released and returned to 100...

No factory block with port

The lift works fine cold or You can run the tractor for an hour and if you don't move the lift control or move a remote level the pump pressure will remain at zero and you can at that point operate the lift and it will work fine for about 15 minutes then lose pressure It will hold a load but...

K thanks I'm planning on going back into it tomorrow or Wednesday and will take a few pics as well

Bought new has never had any work other than I replaced 1 starter it has been incredibly reliable and has mowed thousands of rolls of hay. Wish I could find one brand new.

Changed fluid, oem filter, removed suction line from resuvior to pump no obstruction, no suction screen on this model, hi limit pressure tested 1800psi, adjusted lift arm control and draft per specs exactly, 2 remotes, problem occurs regardless if remotes are connected or not, problem does how...

The guage is in the pressure line directly off the pump, cold start pressure is zero touch any lever lift or spool it doesn't matter the pressure goes to a 1000 and when the lift satisfies it drops to 800 and remains until the pump obviously overheats and slowly loses pressure and and will only...

Perhaps but regardless I posted here looking for answers not ridicule. If I had all the answers I wouldn't have wasted my time asking for those answers on this site. Eventually the information I need will come, thanks.

Maybe you can Maybe not but either way I don't need or want sarcasm. I'm sure there are others that have the answer and luck will not be a factor.

Well Dan I think I have a pretty good idea of how to test pressure and with the guage connected to the pressure side of the pump and listening to the tractor pull down because of a constant load even though there isn't a load not to mention failure of the system after 15 minutes I'm pretty sure...

I could really use some professional advice. After using the tractor for 15 to 20 minutes the hydraulics will slowly fail. I have guaged the the pressure and and upon cranking cold pressure is zero but once you move any lever the pressure increases to approximately 1000psi and once satisfied...