Search results

installed these feild ready stabilizers tonight Photo 1: Shows the product Photo 2: I inverted the steel bracket that hold the stabilizer to the tactor. It nows sits vertical rather than dropping down a bit. By inverting it I gained a a couple of centimeters in addition space for any rear PTO...

$189.00 US

Just ordered these a few days ago. They look like they'll make life much simpler when doing hook-ups with the 3 point.

I wanted to follow up on the Robalon replacement snowblower skid shoes. I've cleared a good amount of snow over the past few weeks. These shoes are awesome. I added an additional cutting blade to the bottom of my blower to get closer to the driveway. I have about am 1/8 inch of snow left on...

I own a 2014 BX 2370 and I'm looking for a good quality hitch for attachments. I've been impressed with Land Pride Hitches, my question. Can anyone let me know what Land Pride hitch will fit my Kubota. I'm new to the wold of tractors and could sure use some guidance. Thanking you all in...

I'll be ordering some of these. Thanks for the tip

Got it free - three days of penetrating oil and impact driver and these "stripped bolt remover" sockets. It's out... now $37.00 for a new vent fill bolt... OUCH Now into repairing the plastic cracked front support bracket.... I'll post some photos of this peice of crap.

That's the same gear housing. I thought the vent was the fill. How would you recommend filling from the front plug?

Of course not.... lol

I'm using a six point socket.

The 11 mm bolt is seized. It's now starting to strip. Any suggestions on how to get this to release. I've sprayed with oil, heated the shit out of it, it won't release

BX2755HD

I'll take some pics of the repair once I get it done.

These are a twin match to the originals, right down to the bolt pattern

Steel shoes scraped the pavement in some spots. I spent a great amount of time looking for replacements. These seem to be the best available.

The 80/90 is better, especially if the tractor is not used regularly. I just did a total fluid and filter change - Hydrolic - Front end gear - engine - fuel filters and air filter.

I'll measure them in the morning for you. They're the exact same size as the steel shoe that came on the blower. I'll post the measurements

I'm trying to figure out some way of bracing the cracked peice. Not sure how successful I'll be. $475.00, plus the time in tearing everything down to get a new Center Pilar in... any thoughts?

Here's the description: PRODUCT DESCRIPTION Robalon replacement snowblower skid shoes are salt, age and wear resistant. Robalon lasts 2-5 times longer than painted steel, and 3-4 times longer than stainless steel or injected molded plastics. They have been factory wear tested for proven long...