Search results

I actually bought a BX 2200 last week. I've been messing with my asc well to get it level. Did you find any online manual? That help me. To adjust the remove the pin and clip and spin up or down to adjust deck side to side. The bolts in the front are front to back adjustment. I have...

I plan on just using a spay bottle and rag since it's mostly clean already.

Ok I plan on trying to shine up my used BX2200. This is how I plan on doing it. 1. Wash with Dawn (I know your not supposed to but this could get the surface dirt and grease free) but the tractor is pretty clean on the body. 2. Wash with Meguiars car wash 3. Use a polish, 4. Wax. Any...

I don't know how it would work, but when I bought my wife's van, I emailed 3 honda dealers with a spec sheet with what we wanted. Took the lowest price quote from a dealer across town to the one closest and they matched it plus gave us 8% off. I did copy all three at once so they could see...

I will measure the gap between the frame and lift arms. I measure everything but that lol. Thanks for pointing that out for me to check........ for the last part of your post...... when I start to lift the deck, the right side starts to lift first, than the left side follows like a second or...

Yes, I have them up all the way but adjust so that the deck is close to even when deck is lowered to cutting height. Deck does not ride on ground. The anti scalp wheels are of the ground by about a quarter inch. (Deck wheels are froze in that position and that's another issue I'm working on...

Ok when I have the deck raise up all the way, it's uneven. When it's lowered at my cutting height,, I have it close to cutting height but not as bad. I've adjusted the bar with the 2 nuts in the rear by the right tire and it still does it. As you can I have the lower mower links all the...

I got two of them that way! The one I cut both ends off and going to try tap them out

Yep! My great uncle used to sell them long time ago. Unfortunately simplicity doesn't seem that good like they used to. I might rig up something similar to a simplicity roller.

I got one pin that's is bent already. Going to be a pia to get that out lol.

Yep I know they shouldn't touch the ground all the time but I'm scalping big time. I think the book says no more than .5 in. I just got the deck level for my 2.5 cutting height. That 60 in deck was a mother to level. Lol. I wish I had a 54.

Got me a new to me BX2200 and all four of the deck wheels are froze. I've soaked them in PB blaster let them soak for a while and such three times. I just need to go a notch lower Any tips?