Search results

Re: Rolled my B7800 last night, now it will not turn-over... It's ALIVE! Pulling the plugs did the trick. A little oil in the rear two cyls. Its running now. Thanks for the help. - C

It's ALIVE! Pulling the plugs did the trick. A little oil in the rear two cyls. Its running now. Thanks for the help. - C

It was on its side for 30 sec before I could shut it off. It did started to burn oil so its safe to assume oil did get into the cylinder(s). I checked all the PTO, 4WD and Trans levers... all are where they should be. I'll look a little closer as I pull the glow plugs. Thx, C.

Re: Rolled my B7800 last night, now it will not turn-over... I'm lucky... I saw it comming and timed my exit. I was towing 2k lbs of sand/stone in a trailer and lost traction going down hill (its mud season in NH). The trailer pushed the tractors back end around, causing a "jackknife"...

Rolled my B7800 last night, now it will not turn-over... Rolled my B7800 last night, now it will not turn-over... Thank God the ROPS was up! I came away with only a few scratches. When I try to start it I get the click but it acts as if its seized. I doubt that the engine is damaged as I...

Rolled my B7800 last night, now it will not turn-over... Thank God the ROPS was up! I came away with only a few scratches. When I try to start it I get the click but it acts as if its seized. I doubt that the engine is damaged as I was able to shut it down within 30 SEC'S of flipping over...