Search results

Check to assure that you are getting a FULL 12 volts to the starter terminal. I had simular problem with my B7100. Thanks to my friendly Kubota mechanic was told to assure voltage is there. Mine was 11.4 volts, no go. found the current draw in my aux. lights. rewired, and away it goes. no...

I am curious as the whether Bellingham has a method of maintaining perpendicularity and/or concentricty if and when he shims or welds his hubs. That is my problem with a home fix. It sure would be more cost effective if there a relatively simple method of establishing those features. This is...

Vic, Is it your recommendation that the wise thing to do is replace the hub? In the diagram I found on line (B7100HST mine is standard gearbox) it appears that the clamp is separate from the hub, yet on my tractor it is welded to the hub. Can you tell me if it should be separate or has someone...

Yes, In fact, it appears what I assume is the spring, is nearly fully compressed. It looks as if it were washers. Based on your response can I add washers to the clamp bolt then retighten. would possibly eliminate the wobble. Thanks again!

Hi Vic, I have a B7100 late 1977. The right rear wheel wobbles. seems the hub has worn or some such thing. The axle measures approx. the same on all flats and on both sides right and left. ( 1.756/ 1.761) I have to assume it is the hub or what appears to be the clamping mechanism on the inner...

I have a Model B219 (serial #1842) loader on my B7100 Kubota. My research indicates that there should be a "float position" when the control lever is pushed past the down position. I assume it should have a detent at that point. In my case there is no detent, the handle just returns to the...

Hi Vic, I am a newbe, Just purchased a B7100 with model 219 loader. Have many questions, But, my first is: The oil light stays lit even after engine starts the fellow I bought it from said "it always does that". But owners manual I aquired says it should go off. Question is; Is the sending unit...